Products
-
JeeLink (v3)
The JeeLink is a fully assembled and ready-to-use USB-type “stick” which plugs directly into a PC or USB hub. It contains Atmel’s ATmega328p AVR microprocessor and HopeRF’s RFM12B wireless radio module. The processor chip is...€32.50
-
JeeNode (v6)
The JeeNode is a small wireless board with an 8-bit Atmel RISC microprocessor. JeeNodes are compatible with the Arduino platform and can be programmed under Windows, Mac OS X, or Linux using sketches created with...€5.00 - €166.50
-
JeeNode Experimenter's Pack
The JeeNode Experimenter's Pack has everything you need to start experimenting with a JeeNode. It's essentially an Arduino plus wireless, ready to use with a large breadboard and wire jumpers. Oh, and it will run off...€63.50
-
JeeNode Micro (v1)
The JeeNode Micro is the little brother of the JeeNode - the main difference is that it's based on the ATtiny84 processor and has only 2 ports instead of 4. It's also considerably smaller: 16 x 48...€3.50 - €15.50
-
JeeNode SMD (v1)
This is a JeeNode built with SMD parts. It contains Atmel’s ATmega328p AVR microcontroller and HopeRF’s RFM12B wireless radio module, and pins to connect to an USB BUB or other FTDI interface. The ATmega is...€5.00 - €23.50
-
JeeNode USB (v3)
This is a JeeNode with a built-in USB interface. It contains Atmel’s ATmega328p AVR microcontroller and HopeRF’s RFM12B wireless radio module, as well as the FT232R USB interface. The ATmega is pre-flashed with the OptiBoot...€5.00 - €32.50
-
LED Node
The LED Node is essentially the combination of a JeeNode, MOSFET Plugs, and the Room Board - in a narrow 18 x 132 mm form factor, making it fit in-line with standard RGB LED strips....€4.50 - €45.00
-
OOK 433 Plug
The OOK 433 Plug is a small board which allows communication to and from wireless devices using 433 MHz with On-Off Keying, as used by many low cost weather sensors, wireless power switches, etc. The...€2.50 - €14.50
-
RFM12B 868 MHz
The RFM12B radio module by HopeRF is a small wireless radio module for sending and receiving packets on the 868 MHz ISM band using FSK. This module is used by all JeeNodes and JeeLinks. It...€5.50
-
Wireless Starter Pack
This JeeLabs Wireless Starter Pack has everything you need to get started with your own 3-node Wireless Sensor Network. Two nodes are pre-assembled and pre-loaded with demo software so you can be up and running...€169.50