SANUS FLF325-B2 Full Motion 47-90" TV Bracket - Fits most 47" - 90" flat-panel TVs - extends 25" This is the SANUS Full-motion TV Mount designed to hold TV’s 47-90 inches and up to 120 pounds. With this mount you can easily extend your TV up to 25 inches out from the wall; allowing you to swivel your TV up to 25 degrees left and right. Amount of swivel will depend on the size of your TV. Position your TV 2.3 inches from the wall for a clean, low-profile look. You can easily tilt your TV down 15 degrees, perfect for eliminating glare from lights and windows - or to get better a viewing experience if you need to mount your TV above a fireplace. Easily level your TV after installation if things don’t end up just right, loosen the screw on the back of the mounting assembly - adjust level, and tighten to hold in place. This mount comes with in-arm cable management so you can easily route, organize and conceal cables along the mount arm. You can also shift your TV left and right on the wall plate to place your TV exactly where want to - even if your studs are off-center. This mount can be installed on wood studs or on concrete - hardware is included for wood stud. SANUS includes a comprehensive TV hardware pack to fit most TV’s on the market today. Bluetooth: N Depth: 60 MM Dongle Required: N Effortless extend, tilt and swivel your TV for the best view Smooth fingertip tilt eliminates glare Easily level your TV after installation Perfect for mounting your TV in a Corner VESA Hole Patterns Supported 200 x 100 to 600 x 400 Swivel (degrees) 50° / -50° Tilt (degrees) +15 / -15 Extension 25" / 63.5cm Depth from Wall 2.38" / 6.5cm Height: 432 MM Width: 695 MM Wifi Enabled: N
